 |
 |
 |
 |
|
Product Detail |
 |
This is the glow powered AquaCraft .18 cu in (3cc) Marine Engine
used in the AquaCraft Miss Vegas, AQUB32**.
FEATURES: ABC cylinder & piston construction "A"luminum piston,"B"rass
cylinder liner with a "C"hrome plating on the cylinder
Dual ball bearing-supported crankshaft
Two needle rotary carburetor
Water cooled cylinder head
Made by O.S. Max
Two year limited warranty
INCLUDES: AquaCraft .18 cu in (3cc) Marine Engine with pull starter, glow plug,
and instruction sheet
REQUIRES: Fuel: 30-65% nitro content and at least 16% lubricant content
Glow Starter and Fuel Bottle
SPECS: Carburetor Settings;
High-Speed Needle: Factory pre-set at 2 turns out, 1-1/4 - 1-3/8
turns out after break-in
Low Speed Needle: 1-2mm gap between needle and spray bar at full
throttle. At idle, pinch fuel line, engine should speed up
for 3-4 seconds and then lose speed. If engine loses RPM quicker
turn needle counterclockwise to open. If engine takes longer
than 5 seconds to slow down turn clockwise then pinch again.
Throttle Stop Screw: 1 turn out
Weight: 7.9oz (225g)
Distance Between Mounting Holes Same Side: .43" (11mm)
Distance Between Mounting Holes Opposite Side: 1.2" (32mm)
Height from Crankcase Bottom to top of Cylinder Head: 2.5" (64.8mm)
Height from bottom of Mounting Tabs to Cylinder Head: 2.1" (53mm)
Width at Mounting Tabs: 1.5" (38.9mm)
Length from Pull Starter to end of Crankshaft: 3.6" (90.9mm)
Length from Pull Starter to Drive Washer: 2.9" (75mm)
Crankshaft Diameter: .20" (5mm)
COMMENTS: Engine is designed to power model boats only. Do not use for any
other purpose.
|
|
 |
 |
|
|
|
 |
 |
 |
