 |
 |
 |
 |
|
Product Detail |
 |
Features
Megatech 16161 Mega Nitor 2 Glow Plug Starter w/Q Plug
Quick release plug lock design (spring loaded) for fast starts
Full charge lasts all day
Fits all glow plugs
Rechargeable hundreds of times
Charge level/glow plug status gauge
Bonus Chris Chianelli Signature Series Glow Plug included (MTCG1692)
Plastic battery case and metal locking mechanism
Specifications
Length: 5.5" (140mm) total length
Shaft only length: 3" (76mm)
Package Contents
One glow igniter with pre-installed battery
One AC wall charger (170 mah charge rate) with 76" (1930mm) long lead
One bonus Chris Chianelli Signature Series glow plug (MTCG1692)
One rubber shaft cap
Requirements
Before using, the initial charge should be 14-16 hours. Subsequent charging time is 12 hours.
Comments
Here is how to read the charge level/glow plug status gauge: Once ignitor is attached to the engine's glow plug, look at the red and green gauge located on top of the ignitor. If the needle points to the green area,the ignitor is charged and the glow plug is good. If the needle points to the red area, either the ignitor needs to be charged or the glow plug is not good. To test the glow plug, unscrew the glow plug from the engine and attach to the ignitor in the same manner as if it were on the engine. The bottom of the glow plug will glow red. if it does not, you must replace the glow plug. If it does glow red but your meter still reads in the red zone, the ignitor needs to be recharged.
|
|
 |
 |
|
|
|
 |
 |
 |
