 |
 |
 |
 |
|
Product Detail |
 |
This is the Futaba 10 CH 10 Channel RC System with the R3110DPS Receiver. No servos included. This version is Mode 2-Left Hand Throttle and Right Hand Elevator, USA Standard This is the helicopter version which will default to helicopter settings, with mode 2 stick operation when powered up and has a non-ratcheted throttle stick.
Features
Futaba 10CH R3110DPS Synthesized Heli 72MHz Md2 NoServo FUTJ9151
Enhanced airplane, heli and glider software
Big 160 x 72 LCD with backlighting, adjustable contrast and auto-off 15 model memory (expandable with optional camPACs)
Smart Switch Technology (SST) logic switches allows activation of a functon when specific switch and/or stick positions occur
Modes 1-4 selectable, modes 3-4 programmable
Assignable functions/switches
Eight programmable mixes (4 linear/(4) w/5-point curves
Nine factory defined mixes: Elevator-Flap, Ailevator (for dual elevator servos), Throttle-Needle, Aileron Differential, Flaperon, V-Tail, Elevon, Snap Roll and Air Brake w/elevator delay Dual/Triple rates (4ch)
Exponential (4ch)
Idle Down
Throttle Cut
Throttle Delay
Throttle Hold & Idle Up with Delay
Two independent gyro settings
7-point throttle curve
Flap Trim
"Full Functionality" trainer system (trainer cord not included)
One year limited warranty
Specifications
Transmitter;
Power Supply: 9.6V NT8S700B NiCd battery
Receiver;
Intermediate Frequency: 10.7MHz & 455kHz
Power Requirement: 4.8V NiCd battery
Current Drain: 40mA
Size: 1.27 x 2.17 x 0.80" (32.2 x 55.2 x 20.3mm)
Weight: 1.25oz (35.5g)
Channels: 10
Contents
10C Transmitter
TP-FSM RF Module
R3110 DPS 10 channel Receiver
NT8S700B 700mAh Transmitter Battery, FUTM1460
FBC-19B4 TX, RX Wall Charger, FUTM1830
Switch Harness
9" Aileron Extension, FUTM3910
Neck Strap, FUTM5690
Screwdriver
Requirements
Servos depending on type of aircraft
Comments
This radio is also available in airplane default mode; FUTJ9150.
|
|
 |
 |
|
|
|
 |
 |
 |
