 |
 |
 |
 |
|
Product Detail |
 |
This is the Futaba 10 CA 10 Channel RC System with the R3110DPS Receiver. No servos included. This version is Mode 2-Left Hand Throttle and Right Hand Elevator, USA Standard This is the airplane version which will default to airplane settings, with mode 2 stick operation when powered up and has a ratcheted throttle stick.
Features
Futaba 10CA R3110DPS Synthesized Air 72MHz Md2 No Servo FUTJ9150
Enhanced airplane, heli and glider software
Big 160 x 72 LCD with backlighting, adjustable contrast and auto-off 15 model memory (expandable with optional camPACs)
Smart Switch Technology (SST) logic switches allows activation of a functon when specific switch and/or stick positions occur
Modes 1-4 selectable, modes 3-4 programmable
Assignable functions/switches
Eight programmable mixes (4 linear/(4) w/5-point curves
Nine factory defined mixes: Elevator-Flap, Ailevator (for dual elevator servos), Throttle-Needle, Aileron Differential, Flaperon, V-Tail, Elevon, Snap Roll and Air Brake w/elevator delay Dual/Triple rates (4ch)
Exponential (4ch)
Idle Down
Throttle Cut
Throttle Delay
Throttle Hold & Idle Up with Delay
Two independent gyro settings
7-point throttle curve
Flap Trim
"Full Functionality" trainer system (trainer cord not included)
One year limited warranty
Specifications
Transmitter;
Power Supply: 9.6V NT8S700B NiCd battery
Receiver;
Intermediate Frequency: 10.7MHz & 455kHz
Power Requirement: 4.8V NiCd battery
Current Drain: 40mA
Size: 1.27 x 2.17 x 0.80" (32.2 x 55.2 x 20.3mm)
eight: 1.25oz (35.5g)
Channels: 10
Contents
10C Transmitter
TP-FSM RF Module
R3110 DPS 10 channel Receiver
NT8S700B 700mAh Transmitter Battery, FUTM1460
FBC-19B4 TX, RX Wall Charger, FUTM1830
Requirements
Servos depending on type of aircraft
Comments
This radio is also available in helicopter default mode; FUTJ9151.
|
|
 |
 |
|
|
|
 |
 |
 |
